Alternator Bracket Support Kit (1900cc)
Kit includes: GoWesty alternator support bracket, all necessary hardware, and instructions.
Fits: This kit is for all 1983-85 Vanagon with the 1900cc waterboxer engine.
The way that VW mounted the alternator on a water boxer was less than ideal. The lower bracket which takes most of the load is a simple cantilever design, held to the block by two 8mm studs. Just behind these studs is the cylinder coolant jacket. When the bearings in the alternator begin to wear out, it starts to vibrate. This vibration leads to a wobble... which leads to the bracket loosening... which leads to severe engine block damage. Read the full story here.
This GoWesty-designed kit greatly reduces the cantilever aspect of the original lower bracket. Our kit utilizes a very strong triangular steel bracket that transfers some of the load to the right cylinder head. Another improvement if you have the standard bolt-style bracket is the utilization of a carriage bolt that slides in from the rear and locks into place in the bracket, allowing you to tighten it from the front without trying to keep the bolt from spinning behind the alternator... which can make a somewhat simple alternator replacement a frustrating affair.
Special installation note: The GW bracket kit is designed to be used in CONJUNCTION WITH your original bracket. If your van does not have power steering please double check that the provisions to add power steering are threaded on the cylinder head.