Sliding Door Rear Arm Roller Bearing

Product:GVW-251-843-361B
Works With:1984-1991
Manufacturer:GoWesty
Difficulty:

Requires some hand & power tools and minimal mechanical knowledge.

Write a review
$20.07
Write a review

Proposition 65: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.
Self-certified made in USA of U.S. and imported parts

Replace your worn-out steel roller bearing on your sliding door with this low-friction solution! The outer roller surface is machined from Delrin®, a super tough material for quiet, low-friction operation. The sealed precision ball bearing keeps out dirt and provides a smooth rolling action. This roller bearing fits the rear "arm" that swings out of the slider track.

Installation Note: You shouldn't need to hammer these bearings on. If the fit over the shaft is snug, take some sandpaper or similar abrasive and clean any corrosion or debris off the shaft before fitting. If any force is needed to seat it, press on the inner race of the bearing, not the outer Delrin® piece.

Please note: this bearing is NOT compatible with our aftermarket Complete Sliding Door Hinge (251-843-336B-AM). It is designed for use on OE models.

Looking to upgrade your all your bearings? Check out our Sliding Door Roller Bundle.

Fits some 1984, and all 1985-91 Vanagon models. If you have an '84, please check to see if your van has this roller. Some earlier models have a plastic bushing in this location (which means this metal roller bushing will NOT fit!).

Sliding Door Rear Arm Roller Bearing Wrench Rating


Handy — Requires some hand & power tools and minimal mechanical knowledge.




All Wrench Ratings



Plug 'n' Play — Requires no or basic hand tools and no mechanical knowledge.


Handy — Requires some hand & power tools and minimal mechanical knowledge.


DIY — Requires a full tool set and broad mechanical knowledge.


Pro — Requires professional-level tools, talent and experience.


Spreadr Button