Pedal Pad For Brake or Clutch

Much better than slick pedals. Soak them in hot water first and they install easily

Let’s take a moment to appreciate an easy upgrade that doesn’t unravel fourteen new issues to address!
* Install note - I recommend soaking the pedals in warm water for a few minutes (150-180 degrees) before install. This helps soften the tough rubber and will allow your fingers to pry the backing around the pedal. Use an air compressor or towel to dry the inside before install to help prevent rust back there.

I struggled getting this on but once I did it looked new again

Once I warmed up the pads, they were easier to put on.

Fit was perfect and product is a complete original factory look. Added bonus is they feel great under your feet! I had forgotten what the good pedals felt like.