On-Board Air Compressor Bundle
$578.95
![Fresh Water Hose (BPA-Free/Silver-Ion)[Westfalia]](http://gowesty.com/cdn/shop/products/full_fdc057c764d4745e5ef0e5a3592a5b0d.jpg?v=1785447495&width=900)
![Fridge Flue Vent Seal (Viton) [Vanagon/Eurovan]](http://gowesty.com/cdn/shop/files/FLUE-SEAL-FKMmain.jpg?v=1785470106&width=900)
![Block-off Plate for Fridge Vent [Vanagon & Eurovan Winnebago]](http://gowesty.com/cdn/shop/files/FLUE-B-GONE_with_screws.jpg?v=1785470095&width=900)
![Decal for Tank Filler Hook-Up [Vanagon]](http://gowesty.com/cdn/shop/products/full_ada71bb27fef84ac8064d3ee573d1ff6.jpg?v=1785445512&width=900)
Gifting has never been easier
Perfect if you're short on time or are unable to deliver your gift yourself. Enter your message and select when to send it.
Hook-Up Door
$6.00
Skip to product information
Hook-Up Door
| Product: | HB-1111 |
|---|---|
| Works With: | 1980-1991 |
| Manufacturer: | GoWesty |
| Availability: | Good Stock |
$6.00
Missing a door flap on one of your GoWesty Hook-Up Boxes? Fear not, replacements are available, here. Don't forget the spring!
*Note: Does not work with original hook-up boxes.
Proposition 65: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.
Complete GoWesty Hook-Up Box Replacement Bundle
$173.00 – $182.00
GoWesty Air Hook-Up Box
$59.00
GoWesty Tank Filler Hook-Up Box
$59.00
GoWesty City Water Hook-Up Box
$59.00
GoWesty 110 Volt Electrical Hook-Up Box
$59.00
15 AMP Hook Up Extension Cord
$53.95
Fresh Water Hose (BPA-Free/Silver-Ion)[Westfalia]
$39.95
Camper City Water Hook-up Hose 25 ft.
$19.95
Water Pressure Regulator
$17.95
Fridge Flue Vent Seal (Viton) [Vanagon/Eurovan]
$15.00
Fresh Water Tank Drain Cap
$14.95
Block-off Plate for Fridge Vent [Vanagon & Eurovan Winnebago]
$14.00
Flex-Line Water Hose
$11.95
Water Bandit Faucet Adapter
$8.95
Water Tank Filler Nozzle
$7.95
Hook-Up Frame (Bare)
$7.00
Hook-Up Door Spring
$6.00
Quick Connect Coupler for GoWesty Hook-ups
$4.95
15A Female to 30A Male, Triangle
$4.95
12V Aux Power Hook-up Decal
$3.95
Solar Power Hook-up Decal
$3.95
Air Compressor Hook-up Decal
$3.95
City Water Hook-Up Decal
$3.95
Decal for Tank Filler Hook-Up [Vanagon]
$3.95
110V/15A Hook-up Decal
$3.95
Hook-Up Box & Vent Cover Stainless Mounting Screws (Pack of 12)
$3.95
Gasket for Hook-Up Box
$2.00
BARGAIN BASEMENT - Camper Sticker "Potable Water Only"
$1.95
D
Perfect
J
Perfect fit
A
I bought to have an extra, you know.. for just in case
J
I installed this on an original base. I had to drill out the hinge holes. Was a
Bear to get this into place. Works great now
J
Works good
R
Easy replacement. Pull the whole box, slide it in, tape the metal slider a little and put it back on!
R
Simple install, great and strong material!
K
In order to replace the old door you must take the whole hookup off the van, then unscrew the insert from the frame. A metal “spring” will fall out as you remove the door from the back of the frame. It just sits on the little stumps at the top of the frame. The wings that bend up go towards the new door that you have to insert from behind the frame. Once you have the new door inserted take a small piece of black electrical tape and tape the “spring” to the frame to prevent it from moving as you reinstall the insert into the frame.
H
How to install?
Remove the Outer Trim Frame
Remove the screws securing the outer trim frame to the hookup box housing. There are screws along all four sides.
Pull the trim frame straight away from the van body to separate it from the housing.
Set the trim frame aside.
Remove the Flat Spring
With the trim frame removed, the flat spring will be accessible — it sits in the gap between the housing and where the trim frame was seated.
Note the orientation of the spring before removing it.
Lift the flat spring out of its seat and set aside.
Remove the Hookup Door
With the trim frame and spring removed, the door is now accessible.
Open the door to expose the hinge pin or hinge tabs at the top.
Slide or lift the door up and off the hinge to separate it from the housing.
H
How to install?
Remove the Outer Trim Frame
Remove the screws securing the outer trim frame to the hookup box housing. There are screws along all four sides.
Pull the trim frame straight away from the van body to separate it from the housing.
Set the trim frame aside.
Remove the Flat Spring
With the trim frame removed, the flat spring will be accessible — it sits in the gap between the housing and where the trim frame was seated.
Note the orientation of the spring before removing it.
Lift the flat spring out of its seat and set aside.
Remove the Hookup Door
With the trim frame and spring removed, the door is now accessible.
Open the door to expose the hinge pin or hinge tabs at the top.
Slide or lift the door up and off the hinge to separate it from the housing.