Starter Relay Kit on white background

Starter Relay Kit (Circuit 50 Load Reduction) [Bus/Vanagon]

$24.00
Skip to product information

Starter Relay Kit (Circuit 50 Load Reduction) [Bus/Vanagon]

Product: STARTER-RELAY-KIT
Works With: 1968-1991
Manufacturer: GoWesty
Availability: Good Stock
Wrench Rating: Requires some hand & power tools and minimal mechanical knowledge.

$24.00

Does this part fit your vehicle? Log in to your account & update your profile!

Starter Relay Kit for Circuit 50 Load Reduction. Get your starter cranking!

Fits: All Bus & Vanagon with original Bosh type starter*

Note: This relay kit works with any starter on any Bus or Vanagon, and comes standard on the Gowesty 003-911-023E starters for automatic transmission.

Frustrated by the “click but no crank” issue with your Bus or Vanagon? This common problem stems from the aging “CRANK” signal (circuit 50) that runs from the ignition switch all the way back to the starter, leading to increased resistance resulting in low voltage and…silence. The extra wiring in vans with automatic transmission makes things even worse, and the original Bosch starter design also contributes to the problem. Read this article!

Our Starter Relay Kit is a 21st-century remake of the old Bosch “WR1 Hard Start” kit. It functions in the same way to reduce the electrical burden on the ignition switch and the entire vehicle wiring system by delivering full power straight to the starter via a relay mounted right on the starter. But that is where the similarities end.

Unlike the generic open-to-the-elements horn relay and the “what goes where?” wiring the old Bosch kit had to offer, the GoWesty Starter Relay Kit employs a state of the art relay and plug that are both fully sealed against moisture and corrosion, as well as a purpose-made harness with wires of the correct length, gauge and color—complete with a fully sealed plug for the “crank already!” to replace the ancient spade terminal on your original wiring. Reliable cranking every time.

Is installation easy? Installation is straightforward with complete instructions and color-coded wiring for a clean and professional setup.

Yeah, GoWesty keeps you cranking!

  • 5 stars: 3 (60%)
  • 4 stars: 0 (0%)
  • 3 stars: 0 (0%)
  • 2 stars: 1 (20%)
  • 1 star: 1 (20%)
J
Jayson B.

Received quickly, easy-ish install (though the directions were a bit vague), and our beloved Clementine started right up and has ever since!

A
Alexander N.

Easy install works fantastic.

C
Charles M.

nice solid kit for reducing electrical load across the ignition switch - some of my preferred projects. easy install.

FOLLOW UP - I discovered the ring terminals on the relay leads are very weak and easily separated from the wire. The crimp was on only 1/8" of stripped wire. Replace these with quality terminals. Good kit and functionally it works as designed, just bad terminal components in my experience.

D
Dgyoung

No instructions came with my kit . The pictures I could look at on the page did not show where all the wires terminate . I would greatly help is a picture of schematics were included with your product.

T
Tod J.
unclear instructions, parts

There are parts included that are not mentioned in the very basic instructions. A yellow plastic, fuse-like piece that doesn't fit to anything. Better photos showing all sides of installation would be helpful.

Hi Tod, thanks for your feedback. We'll take another look at the instructions and see where we can add better detail. All the best, GoWesty.

D
David

In the starter hard start relay kit, the relay body has a metal tab with a hole in it. Is this yo attach yo something. Can't see in any photos or diagrams

GoWesty

Yes, you can pop a screw in that hole and mount it anywhere you like. :)