Let’s take a moment to appreciate an easy upgrade that doesn’t unravel fourteen new issues to address!
* Install note - I recommend soaking the pedals in warm water for a few minutes (150-180 degrees) before install. This helps soften the tough rubber and will allow your fingers to pry the backing around the pedal. Use an air compressor or towel to dry the inside before install to help prevent rust back there.

The pedal pads are a little tight upon installation. The plastic is quite rigid which made the installation difficult. Obviously, you don't want them loose, but ...

Nice product to give your van the detail it needs.

Much better than slick pedals. Soak them in hot water first and they install easily

I struggled getting this on but once I did it looked new again

Once I warmed up the pads, they were easier to put on.

Fit was perfect and product is a complete original factory look. Added bonus is they feel great under your feet! I had forgotten what the good pedals felt like.

These fit perfectly glad to have a little tread back on my brake and clutch

Fresh and new

Good quality. Take your time when installing with a flat blade screwdriver of pick being careful not to puncture. Do not lubricate.

Had to replace the old rotting pads for these grippy new ones that feel great