Note: This rainfly is for all Vanagon Westfalia pop-tops from 1980 - 1991. It is not designed for aftermarket tops such as Riviera, or Country Homes Campers.

This product requires drilling and permanently installing five male snap heads into your fiberglass pop-top. If you are not willing to drill holes in your pop-top, this product will not function properly and should not be purchased. The initial installation is easiest with two people familiar with a tape measure and will take roughly 1 to 2 hours. Once the initial installation has been performed, the rainfly can be set up in the field in under 5 minutes.

It folds up into a small stuff sack that measures 13.5W x 17.5L. The fly attaches along the top (front and sides) with snaps that you install yourself. This requires drilling 5 small 1/8" holes along the inside leading edge of the pop-top itself to attach male snap-in points. This is not visible when the lid is shut, nor does it affect any weather-proofing of the top seal. Along the sides, it uses 1" tabs attached to existing screws for late model tents 1985-1991. Early tents 1980-1984 require adding 2 screws on each side. The bottom front attaches in one of two ways: with webbing and a buckle clip through the cab (snaps near rear view mirror) inside the van, or with add-on long hook straps that can be run down to attach at the bumper or bottom corner of the van. Rain gutter clips hold it on along the sides with another buckle clip in the rear to tension it up.

Step-by-step instructions and hardware are included. Drill and drill bit not included. Let it rain!

Wasser-Stopper Installation Instructions