Gifting has never been easier
Perfect if you're short on time or are unable to deliver your gift yourself. Enter your message and select when to send it.
Porte de raccordement
$6.00
Passer aux informations sur le produit
Porte de raccordement
| Product: | HB-1111 |
|---|---|
| Works With: | 1980-1991 |
| Manufacturer: | GoWesty |
| Availability: | Good Stock |
$6.00
Il manque le clapet d’une de vos boîtes de raccordement GoWesty ? Pas de panique, vous pouvez commander un clapet de remplacement ici. N’oubliez pas le ressort !
*Remarque : ne fonctionne pas avec les boîtes de raccordement d’origine.
Proposition 65: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.
D
Perfect
J
Perfect fit
A
I bought to have an extra, you know.. for just in case
J
I installed this on an original base. I had to drill out the hinge holes. Was a
Bear to get this into place. Works great now
J
Works good
R
Easy replacement. Pull the whole box, slide it in, tape the metal slider a little and put it back on!
R
Simple install, great and strong material!
K
In order to replace the old door you must take the whole hookup off the van, then unscrew the insert from the frame. A metal “spring” will fall out as you remove the door from the back of the frame. It just sits on the little stumps at the top of the frame. The wings that bend up go towards the new door that you have to insert from behind the frame. Once you have the new door inserted take a small piece of black electrical tape and tape the “spring” to the frame to prevent it from moving as you reinstall the insert into the frame.
H
How to install?
Remove the Outer Trim Frame
Remove the screws securing the outer trim frame to the hookup box housing. There are screws along all four sides.
Pull the trim frame straight away from the van body to separate it from the housing.
Set the trim frame aside.
Remove the Flat Spring
With the trim frame removed, the flat spring will be accessible — it sits in the gap between the housing and where the trim frame was seated.
Note the orientation of the spring before removing it.
Lift the flat spring out of its seat and set aside.
Remove the Hookup Door
With the trim frame and spring removed, the door is now accessible.
Open the door to expose the hinge pin or hinge tabs at the top.
Slide or lift the door up and off the hinge to separate it from the housing.
H
How to install?
Remove the Outer Trim Frame
Remove the screws securing the outer trim frame to the hookup box housing. There are screws along all four sides.
Pull the trim frame straight away from the van body to separate it from the housing.
Set the trim frame aside.
Remove the Flat Spring
With the trim frame removed, the flat spring will be accessible — it sits in the gap between the housing and where the trim frame was seated.
Note the orientation of the spring before removing it.
Lift the flat spring out of its seat and set aside.
Remove the Hookup Door
With the trim frame and spring removed, the door is now accessible.
Open the door to expose the hinge pin or hinge tabs at the top.
Slide or lift the door up and off the hinge to separate it from the housing.