GoWesty Vehicle Speed Sensor

Name: GoWesty Vehicle Speed Sensor
Brand: GoWesty
SKU: VSS-VANAGON
Price: 35.94 USD
Availability: InStock
Rating: 4.8 (4 reviews)

Product:	VSS-VANAGON
Works With:	1984-1991
Manufacturer:	GoWesty
Difficulty:	Requires no or basic hand tools and no mechanical knowledge.

4 Reviews

Receive 5% GoBucks credit when you purchase this item online.

Proposition 65: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.

Self-certified made in USA of U.S. and imported parts

This GoWesty Vehicle Speed Sensor (VSS) is designed specifically for the Vanagon application. The GoWesty VSS is a hall effect sensor, which produces a square wave signal. This VSS can be used with any application requiring a square wave VSS signal.

The GoWesty VSS mounts to the back of the speedometer where VW fitted the NLA (no longer available) stock speed sensor on factory cruise control-equipped Vanagons. It can be used as a replacement for the stock speed sensor and simple instructions for this application are included.

*This VSS is intended to work with '84-91 speedometer housings that have a plastic snout for a snap-on speedometer cable. It will not work with speedometers that have a screw-on speedometer cable or a metal snout for a snap-on cable. If you check the cable attachment to your speedometer and find that you don't have a plastic snout for a snap-on cable, you will need to purchase one of our late '84-91 speedometers, sold separately.

The GoWesty VSS was designed in-house and is proudly manufactured in the USA.

NOTE: Installing this VSS in a vehicle with an engine conversion (Subaru, Bostig, etc.) is a custom install. Because the VSS may need to be modified to work with certain engine conversion setups, this product is not covered under warranty when paired with an engine conversion. Each VSS is tested to make sure it is operating properly before shipping out to you.

Vehicle Speed Sensor Installation Instructions

We often get questions about how to test the output of this sensor to diagnose tricky cruise control problems. To test the sensor's output, make sure that the red wire has voltage (key on) and the black wire is grounded. Use a multimeter to measure the voltage between the grey wire and the red wire. Remove the speedometer cable, and slowly turn the cable port on the back of the speedometer. You should see the voltage of the grey wire fall, then rise back to zero relative to the red wire as the speedometer spins.