Power Steering Banjo Bolt with Sensor Fitting

Product:HPSL-BOLT-KIT
Works With:1983-1991
Manufacturer:GoWesty
Difficulty:

Requires some hand & power tools and minimal mechanical knowledge.

1 Review
$15.54
1 Review

Proposition 65: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.
Self-certified made in USA of U.S. and imported parts

This special bolt is used to attach the high pressure power steering hose to the power steering pump. 

Both the OE VW high pressure hoses and the GW aftermarket hose have a fitting that holds the power steering switch, the sensor that tells your fuel injection system when power steering loads rise and may drag your idle slower. To relocate the sensor terminals for easier access, you can install the sensor directly into this bolt and use the included plug and washers to seal the original port. 

Note: DO NOT short the power steering switch wires to ground. One of them is unfused 12V, and shorting it to ground can damage your wiring and ECU. This is an excellent reason to relocate this switch, as the original locations places the terminals treacherously close to the alternator.

Power Steering Banjo Bolt with Sensor Fitting Wrench Rating


Handy — Requires some hand & power tools and minimal mechanical knowledge.




All Wrench Ratings



Plug 'n' Play — Requires no or basic hand tools and no mechanical knowledge.


Handy — Requires some hand & power tools and minimal mechanical knowledge.


DIY — Requires a full tool set and broad mechanical knowledge.


Pro — Requires professional-level tools, talent and experience.


Spreadr Button