Will this rear wheel bearing kit fit my Vanagon?

Yes! This complete rear wheel bearing and seal kit is designed to fit all 1980-1991 Vanagons, including Syncro (4WD) models. It's a comprehensive kit, so you get everything you need for the job. Please note it also fits the rear wheels of the 1968-79 Bus.

What's included in the wheel bearing kit?

This kit includes everything you need for a rear wheel bearing replacement: two outer wheel bearings, two inner wheel bearings, four wheel seals, and two cotter pins for the axle nut. It's a complete solution to avoid any last-minute trips to the parts store.

I'm worried about the fit of the inner bearing race on the stub axle. How can I handle this?

The fit between the stub axle and the inner bearing race is designed to be very tight. You may need to use some force or apply heat to install the bearings. Some customers have had success using a heat source or putting the stub axle and bearing in the freezer before installation to help with fitting the bearing. Ensure you have the right tools, such as a bearing driver.

Rear wheel bearing kit

Name: Wheel Bearing Kit (Rear) [Bus/Vanagon]
SKU: WBR-ALL
Price: 136.95 USD
Availability: InStock

Wheel Bearing Kit (Rear) [Bus/Vanagon]

Product:	WBR-ALL
Works With:	1980-1991
Manufacturer:	Quality Aftermarket
Availability:	Low Stock

$136.95

Does this part fit your vehicle? Log in to your account & update your profile!

This is a complete rear wheel bearing & seal kit. It includes everything you need to complete a wheel bearing job on the rear of any Bus or Vanagon.

Fits: 1968-79 Bus, and all 1980-91 Vanagon, including Syncro.

Kit Includes:
(2) Outer Wheel Bearings
(2) Inner Wheel Bearings
(4) Wheel Seals
(2) Cotter Pins for the Axle Nut

Tech tip: The fit between the stub axle and bearing inner race is designed to be a very slight interference fit (less that .0005”), not a slip-fit. Your used stub axle may be just worn enough for the new bearings to slip right on, but some force and/or heating of the bearings might be necessary-especially if the stub axle is new.

5 stars: 9 (100%)
4 stars: 0 (0%)
3 stars: 0 (0%)
2 stars: 0 (0%)
1 star: 0 (0%)

The kit worked well except would have been nice if a new snap ring and center bushing were provided also.

I’m in Alaska and I appreciate the shipping options provided. And it is very helpful to include the bag of grease needed to pack the bearings.

WestyBoy

Install at the left, side work Ok

onehubcap

It all went together smoothly

High quality and fast shipping as always

All the parts with One purchase!

Kit was nicely complete, but a tip on getting the outer bearing on would have been a time saver.
Everyone should have a ID 2” pipe available to assist in ‘tapping’ on the outer bearing. Another hint…put the stub axle and outer bearing in the Freezer, and then get them when you’re ready for the install.
Good Luck!