Good product and straightforward installation. Just remember to reinstall the splashguard tin at the same time or you’ll have to take it apart and do it again. But you’ll only make that mistake once.

If you haven’t replaced your motor mounts, then you should

works well

easy instal while changing the Oil pump

I had torqued both outer mounts to the factory spec of 15 ft lbs. When going to bolt them to the lower bar, the one that attaches to the van body, the holes didnt line up. So I loosened them to make things work. When I did, I torqued the upper nuts to the studs and, the nuts started just spinning. Not the studs, just the nuts, so the threads inside must be just gone. Happened to both outer ones I received.

Great quality rubber.

Well after who knows how many miles the old had on them, they were finally shot. These mounted up easily and fit perfectly. Since three of the four were torn, gotta say its a bit tighter now.

Can’t complain, best looking on the market too

Stopped the slapping exhaust pipe when the engine was warming up.

Putting on before painting fit perfect