This brand-new aftermarket ignition distributor is a vital component to the proper operation of your engine. It is responsible for delivering spark to each cylinder at just the right moment to ignite the fuel and air mixture.

With these vehicles becoming older by the day, we are seeing more and more poor running (and no-running) issues due to worn-out parts related to this area of the ignition system. Whether it is the distributor itself, the electronic "hall sender," or the lowly but critical cap and rotor, this complete unit will ensure this part of your system is up to snuff. Includes O-ring.

This part Includes:
• New aftermarket distributor
• New hall sensor unit
• New distributor cap
• New ignition rotor
• New distributor drive O-ring

Important installation tip: These new distributors are supplied with a distributor cap and ignition rotor pre-installed. On occasion, the cap will have the incorrect firing order listed. The correct firing order is 1-4-3-2. Please install your ignition wires in this order. Failure to do so will cause your engine to misfire. Also, be sure that the ignition rotor is pressed firmly into place, and bottoms out on the shaft. If the rotor is not fully seated, it may damage the cap (and itself) as it rotates.

Product:	111-905-261
Works With:	1986-1991
Weight:	0.0 lb
Manufacturer:	Quality Aftermarket

Distributor O-Ring 86-91

Related Products

Ignition Distributor 86-91 2.1

Hall Sensor Assembly Kit for Distributor

1.9 & 2.1 Ignition Wire Set

Distributor Cap 86-91

Distributor Cap 86-88